| Materials Needed |
|
|
STYROFOAM™Brand Foam:
Block, 12" x 6" x 1"
Other Materials:
Self-stick craft foam shapes: 5/8" squares, 26 each of two different colors; assorted small circles in contrasting color, 11
Craft foam sheets, one each of two different colors to match craft foam squares
Serrated knife
Candle stub or paraffin
Fine-line black permanent marker
Pencil
Ruler
Scissors
Straight pins (optional)
Thick, white craft glue
|
| Instructions |
| (NOTE: Adults only should handle knives, and this project requires adult supervision.) |
| 1. Wax serrated knife with candle stub or paraffin. Measure and cut a 5" x 5-5/8" piece from foam block. Measure and cut a 2-1/2" x 3-1/8" piece from exact center of larger piece; discard or save for future project. Note: Resulting frame should be 1-1/4" wide all around. |
|
2. Stick one row of foam squares to front of frame around opening, alternating colors. Stick second row of squares to frame outside first row, alternating colors once again. Refer to photo to stick craft foam circles to two opposite corners of frame.
|
| 3. Cut two 1" x 5" strips from first craft foam sheet. Cut two 1" x 5-5/8" strips from second craft foam sheet. Glue strips to corresponding outside frame edges. |
| 4. Cut two 1" x 2-7/16" strips from first craft foam sheet. Cut two 1" x 3-1/16" strips from second craft foam sheet. Glue strips to corresponding inside frame edges, butting ends together as shown. |
| 5. Cut a 3/8" x 3" strip from one craft foam sheet. Bend strip into loop and glue ends to top center back of frame for hanger. Pin hanger in place until glue dries; remove pins. |
| 6. If desired, glue photograph directly to back of frame. To allow changing of photo, cut 4-1/2" x 5" piece from craft foam and glue to center back of frame over opening; apply glue only along three edges of craft foam and let dry. Slide photo into unglued edge of craft foam. |
Form No. 179-01610
|
®™* Trademark of The Dow Chemical Company ("Dow") or an affiliated company of Dow
|
