| Materials Needed |
|
|
STYROFOAM™ Brand Foam:
Cube, 5"
Other Materials:
Decorative papers, 12" x 12" sheets, several coordinating patterns
Scalloped paper trim, 21" length
Metal grommet refills, 3/8", three or more
Sharp pencil
Ruler
Paper trimmer or scissors
Craft knife with sharp blade
Low-temp glue gun and glue sticks
Thick, white craft glue
|
| Instructions |
| 1. Use trimmer to cut six 5-1/8" squares from a variety of papers. |
|
2. Spread thin, even coat of glue onto one side of foam cube. Position paper square over glued foam, flush with one side and top edge; smooth paper with fingers.
|
| 3. Use craft knife to trim excess paper at side and bottom edges. Repeat to cover all sides of cube. Glue scalloped paper trim around top edges of cube. |
| 4. To create pencil holes, use tip of craft knife to make three or more tiny cuts through paper at top of cube in desired locations. |
| 5. Insert sharp pencil into first hole and push 2" straight down into foam; rock pencil around slightly to enlarge hole just a bit. Push grommet into top of hole until it rests against cube. Repeat to create additional pencil holes. |
Form No. 179-01996
|
®™* Trademark of The Dow Chemical Company ("Dow") or an affiliated company of Dow
|
