| Materials Needed |
|
|
STYROFOAM* Brand Foam:
Balls, one each: 4"; 2-1/2"
Other Materials:
Renuzit® LongLast® Adjustable Air Freshener
Clay pot, 4-1/2"
Flat wooden teardrops: 1-3/8" x 2-1/2" (XL), five; 5/8" x 1-1/2" (M), two
Acrylic paints: brown; yellow; tan; sage green
Scrapbooking paper scraps: burgundy; orange linen; brown variegated; tan speckled; green
Silk autumn leaves, six
Acorn, nut, and burgundy berry stem(s)
Half-round black beads, 6mm, two
Lightweight cardboard
Serrated knife
Candle stub or paraffin
Pencil
Ruler
Compass or circle template
Metal tablespoon
Medium flat paintbrush
Disposable palette
Water basin
Paper towels
Sea sponge
Scissors
Craft snip or wire cutters
Low-temp glue gun and glue sticks
Thick, white craft glue
Optional: Glue stick
|
| Instructions |
| 1. Paint pot tan; let dry. Apply second coat; let dry. Moisten sea sponge; squeeze to remove excess water. Sponge paint pot. To sponge paint, dip sponge into paint, press sponge onto paper plate to remove excess, and then apply to surface with up-and-down motion. Let dry. Sponge paint pot sage green in same way; let dry. Open air freshener and place in pot. |
| 2. Wax serrated knife with candle stub or paraffin. Cut 2-1/4"-diameter circle from bottom of 4" foam ball; discard scrap. Use spoon to carve out foam from inside ball, until it fits over top of air freshener. |
| 3. Cut small foam ball in half; reserve one half for a future project. Cut 1-1/2"-diameter circle from one rounded side of 4" ball, 3/4" above flat bottom edge. Use glue gun to glue half-ball to flat area for head. Replace head/body over air freshener. Trim foam at bottom of head if needed until head fits in pot. |
| 4. For feather placement, cut a 1/4"-deep groove across center top of body, beginning and ending 1-3/4" from flat bottom edge. Remove turkey from pot and paint brown; let dry. Apply second coat; let dry. |
| 5. Paint medium teardrops yellow; let dry. Measure and use craft snip to cut 1-1/8" from pointed end of each teardrop. Cut small slit in head for beak placement. Glue teardrop ends into slit as shown, 1/4" apart. |
| 6. Glue bead eyes to head. Cut two 1" x 3" strips from burgundy paper for wattle; glue strips white sides together. When dry, cut wattle pattern from glued paper. Glue wattle under beak, gently curving to add dimension. |
| 7. Measure and use craft snip to cut 2-3/8" from pointed end of each extra-large teardrop. Use white glue or optional glue stick to glue wooden "feathers" to unprinted side of desired papers; let dry. Trim excess. Glue paper to back of feathers in same way, if desired. Use glue gun to glue cut feather ends into slit in body; let dry. Replace turkey over air freshener. |
| 8. Use compass or circle template to cut 4" circle from cardboard. Glue back edge of pot to back edge of circle. Arrange and glue leaves, acorns, nuts, and berries to cardboard. |
| 9. When gel is depleted, replace with a new air freshener. |
Form No. 179-01003
|
®™* Trademark of The Dow Chemical Company ("Dow") or an affiliated company of Dow
|
