| INSTRUCTIONS: |
| 1. Using melon baller or sharp spoon, hollow out 1" hole in foam ball. Twist ball onto top of cone until it fits snugly. Glue in place. |
| 2. Cut dowel into two 5" lengths for arms. Whittle one end of each dowel to a point that can be pushed into cone; sand other end to a smooth point. |
| 3. Following pattern, cut ghost body and arms from white fabric. Sew the body section together using 1/4" seam; trim seam and turn right side out. With seam in back, slip over top of cone and ball, pulling fabric down until it fits snugly over the ball. Fold 1/2" of fabric onto bottom of cone and pin or glue in place; trim excess fabric. Fabric should fit loosely on the cone. |
| 4. Snip a tiny hole in fabric on each side of cone right under the ball head; this is where the dowel arms will be inserted. Push pointed end of dowels through holes and insert 3/4" into cone. |
| 5. Run a thin line of glue along arms; drape the sleeves over the arms. Lightly glue the front and back together at the bottom of the sleeves; it's a little spookier if the front and back are not glued together tightly. |
| 6. Cut mouth and eyes from felt, glue to face. Lightly blush cheeks. |
| 7. Tie ribbon in bow and glue to neck (optional). |
