| 1. Cut sheet of foam to measure 7" x 9". Measure and mark 1 1/2" border around each side. Cut out resulting rectangle from center of sheet. |
| 2. Cut second piece of foam measuring 1" x 1 1/2" x 4 3/4"; trim bottom of piece so it sits back at an angle. This piece will be glued to bottom of back of frame for support. |
| 3. Brush craft glue over front and inner and outer sides of frame. Sprinkle with sand. |
| 4. While glue is wet, push shells directly into surface of STYROFOAM; let dry thoroughly. Brush on Mod Podge Matt Medium to finish. |
| 5. Glue piece of felt measuring 5" x 7" over hole on back of frame, leaving one end open to insert photograph. Select open end based on if frame will be used horizontally or vertically. |
| 6. Glue supporting piece to back of frame. |
Form No. 179-01011
